Owners manual

*Mounting kits sold separately. 10/10/2016
Step 7: Install Hold-down Clamp (Only use on spring above axle
assembly with MTKT). Lower the vehicle to the ground to compress
the springs onto the mounting bracket.
Clamp does not have to be centered on spring.
Bolt one side of the clamp together. (Use the shorter bolt found in
the hardware package of the MTKT). Hold-down clamp
assembly
Slide crossplates over SuperSpring and under mounting bracket.
Attach bolt, washer and nut to the opposite side and secure tightly with wrench.
Step 8: Check final alignments.
Position springs shackles to provide rear rollers with ¾” to 1” forward clearance from any
obstacles. (roller movement is toward the axle on loading) Front rollers only require ¼” clearance
in either direction.
Recheck that no A/C lines or brake cables will be interfered with by the vertical travel of the
SuperSprings.
Step 9: Repeat the same process on the other wheel.
Step 10: Lower the vehicle and remove jack and blocks.
Step 11: Recheck installation to ensure that all a/c lines, brake cables and truck frame will not
interfere with the vertical travel of the SuperSprings.
Step 12: NOW SECURELY RETIGHTEN ALL U-BOLT NUTS. AFTER 200-500 MILES
RETIGHTEN U-BOLTS AGAIN.
SSA11 for Dodge/Mercedes Sprinter 2008 ~ present
For Sprinters (2008~ present) place the provided spacers under each leg of the MTKT to
elevate the mounting bracket so as to accommodate the revised factory raised u-bolt and
spring-plate assembly.
Install the modified u-bolt with the short leg to the inside at the rear to avoid the sway bar.
(additional parts are supplied inside yellow box in a plastic bag) For detail images of the
installation of the Sprinter (2008~ present) see included installation flyer below on page
following.