User manual

51
EN
Screw the door bracket (8) tight with
the enclosed self-tapping hexagon screws
(8 x 15 mm).
Finally, fix the door connector (12) to the
door bracket (8) with the enclosed bolt (9).
NOTE
A straight door connector is supplied pre-assembled,
and this is permanently fixed to the rail.
If you wish to use the bent door connector enclosed (de-
pending upon your door particular configuration), you must
attach this with two hexagon screws (8 x 20) to the straight
door connector (12).
3.
4.
(C) Installation of the door bracket (8)
5.
1.
13
14
Fit the middle support (13) clip at a suitable
place, as near as possible to the middle point
between the door and the door operator head.
Key
13 = Middle support clip
14 = Hexagon screws (8 x 60 mm)
(D) Installation of the middle support clip (13)
Finally, secure the bolt (9) by attaching the se-
curing bolt (11) to prevent it from slipping out.
12
8
9