User manual

54
EN
Carry out reference run for power measurement
1. Press „+“, the
display shows „3“.
2. Press „P“,
„3“ flashes.
3. The door goes up
automatically.
5. The door goes down. 6. After it has stopped, press
„P“, to store the information.
4. After it has stopped,
press the „P“ button
twice.
IMPORTANT
Once you have set the two limits and the reference run for power measurement,
you have fulfilled the basic settings required for safe operation.
If you do not require any further settings, you must conclude programming as
specified in method 1 on page 59, in order to adopt the basic settings you have
just programmed.
After this, you can conclude the following individual settings, either singly or after
all the settings have been programmed, using method 2 on page 59.
7. Conclude the pro-
gramming (refer to
page 59, method 1).
During the reference run there is a risk
of injury, as the door operator develops
extremely strong forces.