User manual

Dismantling the device
27
Dismantling the device
Proceed as follows to remove the tubular motor:
¾ Operate the motor to lower the roller shutter, until the roller shutter is no longer
hanging by the springs and these can be easily released from the winding shaft.
DANGER
Fatal electric shock due to coming into contact with live
components.
¾ Do not carry out any connection work on the device when it is
connected to the current supply.
¾ Make sure that the device is disconnected from the mains power
supply.
¾ Disconnect the cable from the junction or switch box.
¾ Release the securing springs from the winding shaft.
¾ Pull the cotter pin out from the securing hole in the drive bearing's axle pin.
¾ Loosen the screws with which the roller capsule and the winding shaft are
screwed together.
¾ Slide the roller capsule up to the limit stop in the winding shaft.
¾ Pull the device out of the bearings.
¾ Pull the tubular motor out of the winding shaft.
Disposing of the device
The environmentally friendly disposal of operating material, electronic assemblies,
recyclable materials and other parts of the device is regulated by national and
regional laws.
¾ Contact the responsible local authority to obtain precise information on
disposal.
¾ Dispose of the device according to the legal regulations via a specialist disposal
company.
¾ Dispose of electronic components according to the legal regulations in
accordance with the German Electrical and Electronic Equipment Act
(ElektroG).
Technical data
superrollo RM10MS superrollo RM10MM superrollo RM20MM superrollo RM30MM
Torque (Nm) 10 10 20 30
Rotational speed (rpm) 17 15 15 15
Voltage (V) / frequency (Hz) 230/50 230/50 230/50 230/50
Output (W) 121 112 145 191
Current consumption (A) 0.53 0.49 0.64 0.83
System of protection IP 44 44 44 44
Maximum operating time
(min.)
4 4 4 4
Cable length (m) 2.0 2.0 2.0 2.0
Total length (mm) 480 500 500 560
Shaft type SW40 SW60 SW60 SW60
Accessories, included Adapter, driver, drive bearing,
securing clip, adjustment tool
Adapter, driver, drive bearing,
securing clip, adjustment tool
Adapter, driver, drive bearing,
securing clip, adjustment tool
Adapter, driver, drive bearing,
securing clip, adjustment tool
Limit switch range (U) 30 22 22 22