User's Guide

7-5
Installing Novell NetWare
3 If necessary, modify the load command line in the startup.ncf file
so that the proper path to the driver and all appropriate
command line options are specified. See Loading the Driver at
Server Bootup on page 7-5.
The correct syntax to load the Ultra320 driver is:
load [pathname]adpu320 [options]
Command line options are not case sensitive. Placing commas
between command line options is optional. See Loading the
Driver at Server Bootup on page 7-5 for possible values.
Loading the Driver at Server Bootup
To automatically load the adpu320.ham at server bootup, the
startup.ncf file (usually located in your server’s startup directory)
must contain a load command line that specifies the location of the
driver and any appropriate command line options (see Using the
Load Command Line Options on page 7-6). For additional
information on the
startup.ncf file, refer to your NetWare
documentation.
The correct syntax to load the driver is
load [pathname]adpu320.ham [options]
For example, the command line to load the driver from the
c:\nwserver directory, with the verbose= option on is
load c:\nwserver\adpu320 verbose=y
Command line options are not case sensitive. Placing commas
between command line options is optional. See Using the Load
Command Line Options on page 7-6 for possible values.
To modify the
startup.ncf file:
Note: You can also use your DOS text editor to modify the
startup.ncf file.
■ If you are using NetWare 4.2, type load install at the
NetWare prompt and press Enter.
■ If you are using NetWare 5.x or 6.0, type load nwconfig and
press Enter.
ASC-39320D UG.book Page 5 Monday, July 22, 2002 1:42 PM