User's Guide

5-2
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
Installing the Driver When Installing
Windows NT
The adpu320.sys driver is not embedded on the Windows NT 4.0
installation disk and must be added during Windows NT 4.0
installation.
Note: Adaptec recommends that you install Windows NT 4.0
onto a hard disk with a primary active FAT 16 partition, 2 GB
or smaller. Once Windows NT 4.0 is installed and configured
properly, you can use Microsoft's Disk Administrator to
convert the drive to NTFS. This minimizes the number of
variables involved during the installation process and
therefore reduces the possibility of problems.
Note: In order to add or remove SCSI controllers from
Windows NT you must be logged on as Adminstrator.
Completing a Fresh Windows NT 4.0 Installation From Floppy
Disk
1 Start your system with the Windows NT 4.0 Boot Disk in the
floppy disk drive.
2 When prompted, insert disk #2 in your floppy disk drive. After
a few moments you will see a blue screen. To setup
Windows NT 4.0 now, press Enter.
3 Press S to skip auto-detection of your SCSI host adapter.
4 Press S again to specify an additional device.
5 Press Enter to select Others; insert the Ultra320 FMS driver
floppy disk for Windows NT 4.0 into your floppy disk drive.
6 Using the arrow keys, select the following driver and press
Enter:
Adaptec Ultra320 Family PCI SCSI Controller (WinNT4.0)
ASC-39320D UG.book Page 2 Monday, July 22, 2002 1:42 PM