User's Guide

9-2
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
2 The Install Supplemental Drivers screen is displayed. If you
booted off of the Configuration Assistant diskette, replace it
with the Adaptec driver disk, otherwise, insert the Adaptec
driver disk into the floppy disk drive and press F2
(
F2_Continue). (See Chapter B, Creating Driver Floppy Disks for
information on creating driver floppy disks.)
3 On the Select Solaris System Version window, select Solaris OS
2.8 by pressing the Spacebar, then press F2 (
F2_Continue).
4 On the Loading Supplemental Driver Software window, you
will see a progress bar displaying the status of adpu320.itu being
loaded into memory. Then the Continue Supplemental Driver
Installation window is displyed. If you need to install other
drivers, insert them into the floppy disk drive and press F2
(
F2_Continue); otherwise press F4 (F4_Done).
5 The Identified Device Drivers window is displayed. The
adpu320 should be one of the identified drivers. Press F2
(
F2_Continue). The Solaris Device Configuration Assistant
window will be displayed.
If you booted off the Configuration Assistant diskette, reinsert it
into the floppy disk drive and press F2. Otherwise, just Press F2
(
F2_Continue). You will see the Scanning Devices window with a
status bar, then the Identified Devices window will be
displayed. Among the identified devices, look for the line
Adaptec SCSI Card 39320D - Ultra320 SCSI or Adaptec SCSI Card
39320 - Ultra320 SCSI
. If it is not there, please check that you
have the correct driver and SCSI controller.
6 Press F2 again to load all the identified devices. Follow Sun’s
installation documentation to finish the operating system
installation.
7 The installation program requires the Adaptec driver disk at the
end. Reinsert the driver disk, then press Enter as instructed by
the console on the upper left screen.
ASC-39320D UG.book Page 2 Monday, July 22, 2002 1:42 PM