User's Guide

7-10
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
3 If sbackup asks you to select the device driver, select the HP
DIBI-2 Tape Driver, regardless of the type of SCSI tape drive
being attached (for example, even if the tape drive is
manufactured by Wangtek, do not select the Wangtek driver).
Note: Novell also includes a driver called adaptec.nlm. This
driver is not needed and should not be loaded. Adaptec’s
driver module takes advantage of ASPI interface features
bypassed by adaptec.nlm.
Novell publishes a list of SCSI tape drives supported by
sbackup.nlm.
Using a CD with NetWare
Netware 4.2
To use a CD with NetWare 4.2, follow these instructions:
1 Load
adpu320.ham by entering the following line:
:load [pathname]adpu320
2 The
scsicd.cdm driver will auto-load if the device(s) are
detected.
Note: For multiple LUN CDs, enable multiple LUN
scanning with the lun_enable switch (for example, load
adpu320 lun_enable=FF). The lun_enable switch is
needed for
adpu320.ham. Type the following line at the
prompt: scan all luns
3 Enter the following line at the prompt, then note the number
and name of the CD:
:cd device list
4 Enter the number or volume name of the CD at the command
line:
:cd mount [x] [name]
5 Edit the
startup.ncf file to include the load commands in Step 1
and 2 above, if auto-mounting devices.
ASC-39320D UG.book Page 10 Monday, July 22, 2002 1:42 PM