User's Guide

6-2
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
Installing the Driver When Installing
Windows XP
The adpu320.sys driver is not embedded on the Windows XP
intallation CD and must be added during Windows XP installation.
Installing Windows XP (32-bit)
1 Start your system with the Windows XP CD in the CD-ROM
drive.
Note: When using a CD-ROM drive to install Windows XP
from the bootable CD, make sure Bootable CD support is
enabled in either the system or SCSI BIOS Setup Utility. If
these options are not available, boot from the Windows XP
floppy disks.
2 You may see a message:
Press any key to boot from CD.
You have five seconds to press a key to boot off the CD.
3 Press F6 when this message is displayed:
Press F6 if you need to install a third-party SCSI or RAID driver...
4 After a brief delay, a message prompts you to install your
driver. Press S to specify a driver.
5 When prompted, insert the Ultra320 FMS driver floppy disk for
Windows XP into drive
A, and continue.
6 You are presented with a selection of driver choices. Select
Adaptec Ultra320 SCSI Cards (WinXP IA32), and press Enter.
7 If you have no other controllers to add, press Enter to continue
with the Windows XP installation.
8 You will need to restart your computer to finish setting up the
operating system.
ASC-39320D UG.book Page 2 Monday, July 22, 2002 1:42 PM