User's Guide

5-16
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
[xxxxx010] Error issuing command
An error has occurred while the driver was setting up its internal
data structures.
[xxxxx011] Error issuing command
The requested command is not supported by this driver.
[xxxxx012] Error issuing command
[xxxxxx99] Error issuing command
The driver does not recognize the target device.
[xxxxx021] Target device protocol error
An unexpected event occurred during data transfer between the
adapter and target device. Normally, this indicates a faulty or
noncompliant target device.
[xxxxx022] Adapter or target device protocol error
The adapter or target device has broken the communication
protocol. A badly behaving device could cause this message to
appear. Normally this is not a serious problem. If you get this
message frequently over a short period of time, it could indicate
that the device or system is malfunctioning. Unplug or turn off
unused devices to see if the problem persists.
[xxxxx023] Target device parity error
The driver has detected a parity error by the target device.
[xxxxx024] Data overrun or underrun
The adapter was given more or less data than the expected amount
of data.
[xxxxx031] Target device queue full
The target device internal buffer is full.
[xxxxx032] Target device busy
The target device reports a Busy status. Another program may
already be using this device.
ASC-39320D UG.book Page 16 Monday, July 22, 2002 1:42 PM