User's Guide

4-3
Installing Windows 2000
Updating the Driver When Windows 2000 is
Already Installed
To update or install the driver if Windows 2000 is already installed:
1 Start Windows 2000. Windows 2000 will automatically discover
the new hardware and start the Found New Hardware Wizard
to guide you through the driver installation.
2 At the Welcome to the Found New Hardware Wizard window,
click Next.
3 On the Install Hardware Device Drivers screen, select Display a
list of the known drivers for this device, and click Next.
4 Select the Have Disk button. When prompted, insert the
Windows 2000 floppy disk into the floppy disk drive, enter the
following path, then click OK:
a:\win2000
5 Select the Adaptec Ultra320 driver from the list, then click Next.
6 Click Next again to confirm the installation of the driver. You
may get a warning that a Digital Signature was not found.
Check Adaptec’s Web site periodically for updated drivers with
the Digital Signature. Click Yes.
7 When the dirver is copied to your hard dive, click Finish. You
may be required to restart your computer.
Note: Because your Adaptec SCSI Card 39320D is a
dual-channel adapter), be sure to update both references in
the Device Manager before restarting your computer.
ASC-39320D UG.book Page 3 Monday, July 22, 2002 1:42 PM