User's Guide

5-17
Installing Windows NT 4.0
[xxxxx050] Host adapter failure
[xxxxxx9A] Host adapter failure
Your host adapter may not be properly installed or is defective. Try
resetting the adapter in the PCI slot, or try installing it a different
PCI slot.
[xxxxx081] Adapter initialization failure
[xxxxxx8A] Adapter initialization failure
[xxxxxx83] Adapter initialization failure
An error has occurred while the driver was setting up its internal
data structures. Verify that your adapter is supported by this
version of the driver.
[xxxxx089] Unable to allocate memory
This indicates that there may be a problem with the amount of
memory installed in your system. Verify that your system has at
least the minimum amount of memory required by your operating
system.
[xxxxx096] Adapter hardware initialization failure—possible resource conflict
The driver has attempted to initialize the adapter hardware but
failed. This might suggest that the adapter resources (for example,
IRQ) conflict with another board installed in your system.
[xxxxx097] Unable to allocate memory
This indicates that there may be a problem with the amount of
memory installed in your system. Verify that your system has at
least the minimum amount of memory required by your operating
system.
[xxxxx0af] Unable to de-allocate memory that was allocated for a target device
Normally, this is not a serious problem, unless you get this
message frequently over a short period of time. The memory can be
reclaimed by restarting the system.
ASC-39320D UG.book Page 17 Monday, July 22, 2002 1:42 PM