User's Guide

3-3
Configuring the Adaptec SCSI Card 39320D with SCSISelect
Starting SCSISelect
To start SCSISelect:
1 Turn on or restart your computer.
During the startup process, pay careful attention to the
messages that appear on your screen.
2 When the following message appears on your screen, press the
Ctrl-A keys simultaneously (this message appears for only a
few seconds):
Press <Ctrl><A> for SCSISelect (TM) Utility!
3 Select SCSI Channel A or B.
4 From the menu that appears, use the arrow keys to move the
cursor to the option you want to select, then press Enter.
Exiting SCSISelect
To exit SCSISelect:
1 Press Esc until a message prompts you to exit (if you changed
any settings, you are prompted to save the changes before you
exit).
2 At the prompt, select Yes to exit, then press any key to restart
the computer. Any changes you made in SCSISelect take effect
after the computer restarts.
Post Display Mode Verbose, Silent,
Diagnostic
Ver bo se
SCSI Controller INT 13 Support Enabled
Disabled: Scan
Bus
Disabled: Not Scan
Enabled
Domain Validation
2
Enabled, Disabled Enabled
Support Removable Disks Under
INT 13 as Fixed Disks
2
Disabled,
Boot Only,
All Disks
Disabled
BIOS Support for Bootable CD-ROM
2
Enabled, Disabled Enabled
1
Setting is valid only if Multiple LUN Support is enabled.
2
Settings are valid only if host adapter BIOS is enabled.
SCSISelect Options Available Settings Default Setting
ASC-39320D UG.book Page 3 Monday, July 22, 2002 1:42 PM