User's Guide

3-2
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
The default settings are appropriate for most systems and should
not be changed. Run SCSISelect if you need to change or view
current settings, or if you need to use the SCSI disk utilities. See the
descriptions of each option, starting on page 3-4.
SCSISelect Options Available Settings Default Setting
SCSI Bus Interface Definitions:
SCSI Controller ID 0-15 7
SCSI Controller Parity Enabled
Disabled
Enabled
SCSI Controller Termination:
Ch. A
Ch. B
Automatic,
Enabled, Disabled
Automatic,
Enabled, Disabled
Automatic
Automatic
Boot Device Configuration Options
—BBS Systems Only:
Select Master SCSI Controller A, B A
Boot Device Configuration—Non-BBS Ssystems Only:
Select Master SCSI Controller A, B A
Boot SCSI ID [Auto-sync] 0-15 0
Boot LUN Number
1
[Auto-sync] 0-7 0
SCSI Device Configuration Options:
Sync Transfer Rate (MB/sec) 320, 160, 80.0, 66.6,
40.0, 33.3, 20.0,
10.0, ASYN
320
Packetized Yes, No Yes (Enabled)
QAS Yes, No Yes (Enabled)
Initiate Wide Negotiation Yes, No Yes (Enabled)
Enable Disconnection Yes, No Yes (Enabled)
Send Start Unit Command Yes, No Yes (Enabled)
BIOS Multiple LUN Support
1
Yes, No No (Disabled)
Include in BIOS Scan
2
Yes, No Yes (Enabled)
Advanced Configuration:
Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled
Display <Ctrl> <A> Messages during
BIOS Initialization
[Auto-sync]
Enabled, Disabled Enabled
Extended INT 13 Translation for
DOS Drives > 1 GByte
Enabled, Disabled Enabled
ASC-39320D UG.book Page 2 Monday, July 22, 2002 1:42 PM