User's Guide

8-6
Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)
3 Type y and press Enter when the computer asks if you really
want to shut down.
System Is Down should appear on the screen.
The UnixWare/Open Unix kernel is now ready for host adapter
operation.
Boot the New Kernel
To reboot the computer with the new kernel:
1 Follow the on-screen instructions (usually by pressing Enter) to
reboot your computer.
2 Check the bootup messages to verify that all your installed SCSI
devices are listed.
If some or all of your installed SCSI devices do not appear at
this time, your SCSI cables may be loose, or the SCSI device
setup may not be complete. If so, go back and correct any
problems before proceeding.
3 Wait for UnixWare/Open Unix to complete bootup with the
new kernel.
Refer to Troubleshooting on page 8-9 if the computer crashes or if
panic (UnixWare/Open Unix ) messages appear during bootup.
The updated driver for UnixWare/Open Unix should now be
ready to use.
ASC-39320D UG.book Page 6 Monday, July 22, 2002 1:42 PM