User`s manual

1-6

Introduction

X6DH8-XG2/X6DHE-XG2 User's Manual

Motherboard Features

CPU

• Single or dual Intel

604-pin Nocona

(w/EM64T) processors at 800

MHz front side (system) bus speed. (*Notes: CPU FSB speed is set by

Manufacturer. Please do not change the FSB setting. Please refer to the support section of

our web site for a complete listing of supported processors (http://www.supermicro.com/

products/.)

Memory

• Eight 240-pin DIMM sockets supporting up to 16 GB Registered ECC

DDR2-400 (PC3200) SDRAM

Notes: 1. Memory size is set via BIOS. 2. Interleaved memory; requires memory modules to be

installed in pairs. See Section 2-3 for details.

Chipset

• Intel E7520 Lindenhurst chipset

Expansion Slots

• X6DH8-XG2/X6DHE-XG2

One PCI-E slot (x8@4GB/sec)

Five 64-bit PCI-X slots (*Three PCI-X-133 slots, One PCI-X-100 slot, One

PCI-X-100 w/ZCR suport)

BIOS

• 8 Mb Phoenix

Flash ROM

• DMI 2.1, PCI 2.2, ACPI 2.0, Plug and Play (PnP), SMBIOS 2.3

PC Health Monitoring

• Onboard voltage monitors for CPU cores, chipset voltage, 3.3V, +5V,

+12V and 3.3V standby

• Fan status monitor with firmware/software on/off control

• CPU/chassis temperature monitors

• Environmental temperature monitor and control

• CPU fan auto-off in sleep mode (S1 is not supported.)

• CPU slow-down on temperature overheat

• CPU thermal trip support for processor protection, +5V standby alert

LED

• Power-up mode control for recovery from AC power loss