User`s manual

2-6

X6DH8-G2+/X6DHE-G2+ User's Manual

UPER X6DH8-G2+

To Remove:

Use your thumbs

to gently push

near the edge of

both ends of the

module. This

should release it

from the slot.

Figure 2-2. Installing and Removing DIMMs

To Install: Insert module vertically and press down until it snaps

into place. Pay attention to the notch at the bottom.

2-3 Installing DIMMs

DIMM Installation (See Figure 2-2)

1. Insert the desired number of DIMMs into the memory slots, starting with Bank

1. The memory scheme is interleaved, so you must install two modules at a

time, beginning with Bank 1, then Bank 2, and so on.

2. Insert each DIMM module vertically into its slot. Pay attention to the notch along

the bottom of the module to prevent inserting the DIMM module incorrectly.

3. Gently press down on the DIMM module until it snaps into place in the slot.

Repeat for all modules (see step 1 above).

Memory Support

The X6DH8-G2+/X6DHE-G2+ supports up to 16 GB of Registered ECC DDR2-400

(PC3200) memory.

Warning! Exercise extreme care when installing or removing

DIMM modules to prevent any possible damage. Please note that

the memory interleaved to improve performance.

o ® i ®o ®DDRII®S ot

Release Tab