User`s manual

Chapter 2: Installation
2-3
1. Do not apply any thermal compound to
the heatsink or the CPU die-the required
amount has already been applied.
2. Place the heatsink on top of the CPU so
that the four mounting holes are aligned with
those on the retention mechanism.
3. Screw in two diagonal screws (ie the #1
and the #2 screws) until just snug (-do not
fully tighten the screws to avoid possible
damage to the CPU.)
4. Finish the installation by fully tightening
all four screws.
CEK Passive Heat-
sink
Screw#1
Screw#2
CEK Heatsink Installation
IMPORTANT: Due to the weight of the CEK Passive Heatsink (which weights about
1KG), you need to have Heatsink Mounting plate installed on the chassis to prevent
damage to the CPU and the motherboard)