Datasheet

Chapter 2: Installation
2-11
Extra Universal Serial Bus
Headers
Extra USB headers (USB2/USB3
on the X5DP8-G2/X5DPE-G2/
X5DPi-G2, FPUSB0/FPUSB1 on the
X5DPR-8G2+/X5DPR-iG2+) can be
used for front side USB access.
You will need a USB cable (not in-
cluded) to use either connection.
Refer to the tables on the right for
pin definitions. An additional
header (USB4) designated J27 is
also provided on the X5DP8-G2/
X5DPE-G2/X5DPi-G2.
Note: the X5DP8-G2/X5DPE-G2/
X5DPi-G2 boards all have an addi-
tional USB header (designated USB
4), which is located near the Chas-
sis Fan 3 header. You should be
aware that this header is not a
Legacy-supported header. This
means that any device attached to
this USB header will not operate
outside of the operating system.
Pin
Number
2
4
6
8
10
Definition
Power
-
+
Ground
Key
USB2 Pin
Definitions (J13)
Pin
Number
1
3
5
7
9
Definition
Power
-
+
Ground
Key
USB3 Pin
Definitions (J14)
Front Panel Universal Serial Bus Pin
Definitions
Pin
Number Definition
1+5V
2P0-
3P0+
4 Ground
5 N/A
Pin
Number Definition
1+5V
2P0-
3P0+
4 Ground
5Key
USB2/FPUSB0
USB3/FPUSB1
Serial Ports
The COM1 serial port is located
under the parallel port (see Figure
2-3). See the table on the right for
pin definitions. The COM2 connec-
tor is a header on the motherboard
(see pp. 1-6, 1-8 for location).
Serial Port Pin Definitions
(COM1, COM2)
Pin Number Definition
1 CD
2 RD
3 TD
4 DTR
5 Ground
Pin Number Definition
6 DSR
7 RTS
8 CTS
9 RI
10 NC
GLAN1/2 (Ethernet Ports)
Two Ethernet ports (designated
GLAN1 and GLAN2) are located
beside the VGA port on the IO
backplane. These ports accept
RJ45 type cables.
Note: Pin 10 is included on the header but not on
the port.