User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Installation
- 2-1 Standardized Warning Statements
- 2-2 Static-Sensitive Devices
- 2-3 Motherboard Installation
- 2-4 Memory Support
- 2-5 Connectors/IO Ports
- 2-6 Connecting Cables
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- Fan Headers (FAN1 ~ FAN4) (FAN4 is available on PCB 2.00 only)
- Chassis Intrusion
- System Management Bus Header
- DOM PWR Connector
- TPM Header/Port 80 Header
- Overheat LED Header
- Speaker
- Standby Power
- I-SGPIO1/I-SGPIO2
- NVMe I2C Header
- Power SMBus (I2C) Connector (available on PCB 2.00 only)
- System Management Bus Header
- GPIO Header
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- 2-7 Jumper Settings
- 2-8 Onboard Indicators
- 2-9 SATA Connections
- Chapter 3 Troubleshooting
- Chapter 4 BIOS
- Appendix A BIOS Error Beep Codes
- Appendix B Software Installation Instructions
- Appendix C UEFI BIOS Recovery Instructions
- Appendix D Dual Boot Block
Chapter 4: AMI BIOS
4-19
Onboard LAN2 Option ROM
Use this option to select the type of device installed in LAN Port 2 used for system
boot. The options are Disabled and PXE.
Onboard LAN3 Option ROM
Use this option to select the type of device installed in LAN Port 3 used for system
boot. The options are Disabled and PXE.
Onboard LAN4 Option ROM
Use this option to select the type of device installed in LAN Port 4 used for system
boot. The options are Disabled and PXE.
Onboard Video Option ROM
Use this item to select the Onboard Video Option ROM type. The options are Dis-
abled, Legacy, and EFI.
VGA Priority
This feature allows the user to select the graphics adapter to be used as the primary
boot device. The options are Onboard and Offboard.
Network Stack
Use this feature to enable PXE (Preboot Execution Environment) or UEFI (Unied
Extensible Firmware Interface) for network stack support. The options are Disabled
and Enabled.
*If the item above set to Enabled, the four items below will appear:
IPv4 PXE Support
Use this feature to enable IPv4 PXE boot support. The options are Enabled and
Disabled.
IPv6 PXE Support
Use this feature to enable IPv6 PXE boot support. The options are Enabled and
Disabled.
PXE boot wait time
Use this option to specify the number of times media will be checked. Press "+" or
"-" on your keyboard to change the value. The default setting is 0.
Media detect count
Use this option to specify the number of times media will be checked. Press "+" or
"-" on your keyboard to change the value. The default setting is 1.