User`s manual

6-2
S
UPERSERVER 6035B-8R+ User's Manual
Figure 6-1. Front and Rear Chassis Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all ex-
cess cabling out of the airfl ow path. The LEDs inform you of system status. See
Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1
can be found in Chapter 5.
Slim DVD-ROM Drive
Hard Drives (16)
USB Ports (2), COM Port Floppy Drive (optional) Control Panel
Power Supplies (2)
Keyboard/Mouse Ports
USB0/1 Ports
COM1 Port
Parallel Port
VGA Port LAN1/2 Ports
PCI Expansion Slots (7)