User`s manual

Chapter 5: Advanced Serverboard Setup
5-21
Compact Flash Master/Slave
Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select jumper is located at
JCF1. Close this jumper to enable the
use of a compact fl ash card. For the
compact fl ash card and JCF1 to work
properly, you will fi rst need to connect
the compact fl ash card's power cable
to JWF1. See the table on the right for
jumper settings.
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Defi nition
Open Slave (Secondary)
Closed Master (Primary)
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SMBUS to PCI Enable/
Disable
The J27 and J28 pair of jumpers allows
you to connect the System Manage-
ment Bus to the PCI expansion slots.
The default setting is closed (on) for
both jumpers to enable the connection.
Both connectors must be set the same
(J27 is for data and J28 is for the clock).
See the table on right for jumper set-
tings.
SMBUS to PCI
Enable/Disable
(J27/J28)
Jumper Setting Defi nition
Closed Enabled
Open Disabled