User`s manual

5-16
S
UPERSERVER 6035B-8R+ User’s Manual
ATX PS/2 Keyboard and
PS/2 Mouse Ports
The ATX PS/2 keyboard and the PS/2
mouse ports are located on the I/O
back plane. See the table on the right
for pin defi nitions.
Power LED/Speaker
On the JDI header, pins 1-3 are for
a power LED, pins 4-7 are for the
speaker. See the table on the right
for speaker pin definitions. Note:
The speaker connector pins are for
use with an external speaker. If you
wish to use the onboard speaker, you
should close pins 6-7 with a jumper.
PS/2 Keyboard and
Mouse Port Pin
Defi nitions (Kb, Mouse)
Pin# Defi nition
1 Data
2NC
3 Ground
4 VCC
5 Clock
6NC
Speaker Connector
Pin Defi nitions (JD1)
Pin # Function Defi nition
4 + Speaker data (red wire)
5 Key No connection
6 Key
7 Speaker data
Universal Serial Bus
Headers
Three USB headers are located near
the WOL header on the serverboard.
JUSB2 includes USB2/3 and JUSB3
is for USB4. These are included for
connection to the ports on the front
of the chassis. A USB cable (not
included) is needed for the connec-
tion. See the table on the right for
pin defi nitions.
Universal Serial Bus Headers
Pin Defi nitions (JUSB2/3)
USB2
Pin # Defi nition
USB3
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 N/A
Overheat LED
Connect an LED to the JOH header to
provide warning of a chassis overheat-
ing condition. See the table on the
right for pin defi nitions.
Overheat LED
Pin Defi nitions (JOH)
Pin# Defi nition
1 +5V
2 OH Active