User`s manual

2-10
S
UPERSERVER 6035B-8R+ User's Manual
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SCSI drives
and SCSI backplane have been properly installed and all connections have been
made.
1. Accessing the drive bays
All drives are accessable from the front of the server. For servicing the DVD-ROM
and fl oppy drives, you will need to remove the top chassis cover. The SCSI disk
drives can be installed and removed from the front of the chassis without removing
the top chassis cover.
2. DVD-ROM and fl oppy disk drives
A slim DVD-ROM and a fl oppy drive should be preinstalled in your server. Refer
to Chapter 6 if you need to reinstall a DVD-ROM and/or fl oppy disk drive to the
system.
3. Check the SCSI disk drives
Depending upon your system's confi guration, your system may have one or more
drives already installed. If you need to install SCSI drives, please refer to Chapter
6.
4. Check the airfl ow
Airfl ow is provided by three 8-cm chassis cooling fans and two 8-cm rear chassis
exhaust fans. An air shroud is also included in the system to maximize airfl ow. The
system component layout was carefully designed to direct suffi cient cooling airfl ow
to the components that generate the most heat. Note that all power and data cables
have been routed in such a way that they do not block the airfl ow generated by the
fans.
5. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the power
cord(s) from the power supply unit(s) into a high-quality power strip that offers pro-
tection from electrical noise and power surges. It is recommended that you use an
uninterruptible power supply (UPS).