User`s manual

2-6

UPERSERVER 6035B-8R+ User's Manual

Installing the Server into the Rack

Locate the front and rear brackets that on both ends of the outer chassis rail. These

brackets sit perpendicular to the rail and are used to attached the rail to the rack.

Secure the front bracket to the rack with two screws and the rear bracket to the

rack with four screws using the appropriate screws and washers included in the

hardware kit (see Figure 2-3). You may need to adjust the rail to match the depth

of the rack. Repeat the same steps to install the other outer rail to the rack.

You are now ready to install the server into the rack. Slide the chassis into the

rack as shown in Figure 2-4. The chassis may not slide into the rack smoothly or

easily when installed the ﬁ rst time. Some adjustment to the slide assemblies might

be needed for easier installation.

When the server has been pushed completely into the rack, you should hear the

locking tabs "click". You'll need to release the safety taps on both sides of the

chassis in order to completely remove the chassis out of the rack.

Figure 2-3. Assembling the Rack Rails

Screws

Front Bracket

Rear Bracket