User`s manual

SC836 Chassis Manual
5-4
Place the hard drive carrier on a at, stable surface such as a desk, table, or 2.
work bench.
Slide the hard drive into the carruer with the printed circuit board side facing 3.
down.
Carefully align the mounting holes in the hard drive and the carrier. Make sure 4.
the bottom of the hard drive and bottom of the hard drive carrier are ush.
Secure the hard drive using all six (6) screws.5.
Replace the drive tray into the chassis. Make sure to close the drive carrier 6.
using the drive carrier handle.
Hard Drive
Carrier
SAS/SATA or SCSI
Hard Drive
Figure 5-3: Installing a SAS or SATA Drive to Hard Drive Carrier
Use a hard, stable
surface when installing
the hard drive
Warning! Enterprise level hard disk drives are recommended for
use in Supermicro chassis and servers. For information on rec-
ommended HDDs, visit the Supermicro Web site at http://www.
supermicro.com/products/nfo/files/storage/SAS-1-CompList-
110909.pdf
!