User`s manual

75
Chapter 7: 10-Gb Ethernet Switch Firmware
Priority Specifies the port priority used in role selection.
Path Cost Specifies the path cost associated with this port.
Protocol Migration
This is to control the migration among MSTP, RSTP and STP protocols, if
the other side of the switch runs a different mode. Migration takes place
only if this is enabled.
Edge Port This must be configured, if the corresponding port is an edge port.
Point-to-Point Status
You can configure the ports explicitly as Point-to-Point (Force true),
Non-Point-to-Point port or leave the decision to be made dynamically
(from AL or MAC layer).
Hello Time (Secs) Specifies administrative value of hello time for the port.
Auto Edge Status If set to True, the edge port status will be dynamically calculated.
Restricted Role Specifies the Restricted role status of the port.
Restricted TCN Indicates the Restricted TCN status of the port.
Table 7-42. CIST Settings Page Parameters (Continued)
Parameter Description