User`s manual

39
Chapter 7: 10-Gb Ethernet Switch Firmware
IP Extended ACL
Clicking on the IP EXTENDED ACL tab brings up the IP EXTENDED ACL CONFIGURATION
page (Figure 7-31). This page displays the various parameters required to configure the
Extended IP access lists. Table 7-23 lists the parameters found on this page.
Ports List (Incoming)
Specifies the Incoming Port List for which the access lists has to be
applied.
Ports List (Outgoing)
Specifies the Outgoing Port List for which the access lists has to be
applied.
Figure 7-31. IP Extended ACL Configuration Page
Table 7-23. IP Extended ACL Configuration Page Parameters
Parameter Description
ACL Number
Specifies the unique ID for the access list. This value must be in the range
from 1001 to 65535.
Action
Specifies whether the packets must be allowed or dropped when a match
has been found.
Source and Destination IP
Address
Specifies the IP Address for which the access list must be applied.
Subnet Mask Specifies the Address Mask corresponding to the IP Address.
Table 7-22. IP Standard ACL Configuration Page Parameters (Continued)
Parameter Description