User's Manual (1.0)

Chapter 6: Advanced Chassis Setup

6-3

6-3 Chassis Cover

Before operating the server for the rst time, it is important to remove the protective

lm covering the top of the chassis, in order to allow for proper ventilation and

cooling.

Removing the Chassis Cover and Protective Film (Figure 6-2)

1. Remove the two screws which secure the top cover onto the chassis as shown

above.

2. Lift the top cover up and off the chassis.

3. Peel off the protective lm covering the top cover and the top of the chassis

4. Check that all ventilation openings on the top cover and the top of the chassis

are clear and unobstructed.

Figure 6-2. Removing the Chassis Cover

Remove Two Screws

Check Ventilation

Openings

Caution: Except for short periods of time, do not operate the server without the

cover in place. The chassis cover must be in place to allow proper airow and

prevent overheating.