User's Manual (1.0)

5-20
SUPERSERVER 6027PR-HT(R/TR/FR) USER'S MANUAL
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system moni-
tor that can reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an ap-
plication hangs. Close pins 2-3 to gen-
erate non-maskable interrupt signals
for the application that hangs. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
the BIOS.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
VGA Enable (JPG1)
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
BMC Enable (JPB1)
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enable (Default)
Pins 2-3 Normal
GLAN Enable/Disable
JPL1 enables or disables the LAN
Port 1 (JPLAN1) on the serverboard.
See the table on the right for jumper
settings. The default setting is
Enabled.
GLAN Enable (JPL1)
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
VGA Enable
Jumper JPG1 allows the user to
enable the onboard VGA connectors.
The default setting is 1-2 to enable the
connection. See the table on the right
for jumper settings.
BMC Enable
Jumper JPB1 allows you to enable
the onboard BMC (Baseboard
Management) Controller to provide
IPMI 2.O/KVM support on the
serverboard. See the table on the
right for jumper settings.