User's Manual (1.0)
6-2
SUPERSERVER 1028R-MCT/MCTR User's Manual
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Installation."
6-3 System Cooling
Four 4-cm fans provide the cooling for the system. The SC113MFAC2 chassis
provides two additional open fan housings, where additional system fans may be
added for optimal cooling.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2.
Control Panel
SAS/SATA Drive Bays
PCI Expansion SlotPower Supply
I/O Ports
1028R-MCT
PCI Expansion SlotPower Supplies
I/O Ports
1028R-MCTR