Datasheet

26 Datasheet
11.These specifications apply to the PLL power pins VCCA, VCCIOPLL, and VSSA. See Section 2.3.2 for details. These
parameters are based on design characterization and are not tested.
12.This specification represents a total current for all GTLREF pins.
13.The current specified is also for HALT State.
14.The maximum instantaneous current the processor will draw while the thermal control circuit is active as indicated by the
assertion of the PROCHOT# signal is the maximum I
CC
for the processor.
15.I
CC_TDC
(Thermal Design Current) is the sustained (DC equivalent) current that the processor is capable of drawing indefinitely
and should be used for the voltage regulator temperature assessment. The voltage regulator is responsible for monitoring its
temperature and asserting the necessary signal to inform the processor of a thermal excursion. Please see the applicable
design guidelines for further details. The processor is capable of drawing I
CC_TDC
indefinitely. Refer to Figure 2 for further
details on the average processor current draw over various time durations. This parameter is based on design characterization
and is not tested.
16.This specification refers to platforms implementing a power delivery system that complies with VR 10.0 guidelines. Please see
the Voltage Regulator Module (VRM) and Enterprise Voltage-Regulator-Down (EVRD) 10.0 Design Guidelines for further
details.