User`s manual

Chapter 2: Installation
2-27
TPM Support Enable
JPT1 allows the user to enable TPM (Trust-
ed Platform Module) support to enhance
data integrity and system security. See the
table on the right for jumper settings. The
default setting is enabled.
TPM Support Enable
Jumper Settings
Jumper Setting Denition
1-2 Enabled
(Default)
2-3 Disabled
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
can reboot the system when a software ap-
plication hangs. Close pins 1~2 to reset the
system if an application hangs. Close pins
2~3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Denition
Pins 1-2 Reset
(default)
Pins 2-3 NMI
Open Disabled
A
B
C
A
TPM Enable
Watch Dog Enable
B