User`s manual

Chapter 2: Installation
2-33
LSI 1068E
NIC4 LED
JBMC1
SAS Enable/Disable
Jumper Settings
Jumper Settings Denition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
SAS Enable/Disable (X8STi-3F Only)
JPS1 allows you to enable or disable
SAS Connectors. The default position is
on pins 1 and 2 to enable SAS. See the
table on the right for jumper settings.
SAS RAID Mode Select
Jumper Settings
Settings Denition
Close Software RAID Enabled (Default)
Open IT Mode Enabled
SAS RAID Mode Select (X8STi-3F
Only)
JPS2 allows you to select the SAS RAID
m o d e . Yo u c a n u s e e it h e r S o f t w a r e R A I D
or IT Mode. Close this jumper to use
Software RAID (Default). Set this jumper
to open to use the IT Mode.
A
B
A. RAID Enable
B. SAS RAID Mode Se-
lect