User`s manual

5-14
X8QB6-F/X8QBE-F Motherboard User’s Manual
SATA#1 Confi guration
If Compatible is selected, it sets SATA#1 to the legacy_compatible mode. Select-
ing Enhanced sets SATA#1 to the native SATA mode. The options are Disabled,
Compatible and Enhanced.
Confi gure SATA#1 as (Not available when SATA#1 Confi guration is
disabled)
Use this feature to select the drive type for SATA#1. The options are IDE, RAID
and AHCI. (When the option-RAID is selected, the item-ICH RAID Code Base
will appear. When the option-AHCI is selected, the item-ICH AHCI Codebase
will be available.)
ICH RAID Code Base (Available when the option-RAID is selected.)
Select Intel to use Intel's SATA RAID fi rmware to confi gure Intel's SATA RAID
settings. Select Adaptec to use Adaptec's SATA RAID fi rmware to confi gure
Adaptec's SATA RAID settings. The options are Intel and Adaptec.
ICH AHCI Codebase (Available when the option-AHCI is selected.)
Use this feature to select the AHCI Codebase for the ICH South Bridge. The
options are BIOS Native Module and Intel AHCI ROM.
SATA#2 Confi guration (Available when the option-IDE is selected.)
Select Enhanced to set SATA#2 to Native SATA mode. The options are Disabled
and Enhanced.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third IDE Master,
and Fourth IDE Master
These settings allow the user to set the parameters for the slots indicated above.
Press <Enter> to activate the following submenu items. Set the correct confi gura-
tions accordingly. The items included in the submenu are listed below.
Type
Use this item to select the type of device connected to the system. The options
are Not Installed, Auto, CD/DVD and ARMD.
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk drive.
In the LBA mode, the maximum drive capacity is 137 GB. For drive capacities
over 137 GB, your system must support a 48-bit LBA mode. If not, contact your
manufacturer or install an ATA/133 IDE controller card that supports 48-bit LBA
mode. The options are Disabled and Auto.