User`s manual

4-16

X8DTU/X8DTU-F User’s Manual

Serial Port 2 Attribute

This feature allows the user to set COM 2 as a normal serial port or a virtual COM

port used for SOL (Serial Over LAN). The options are SOL, and COM.

Remote Access Conﬁ guration

Remote Access

This allows the user to enable the Remote Access feature. The options are Disabled

and Enabled. If Remote Access is set to Enabled, the following items will display:

Serial Port Number

This feature allows the user to decide which serial port to use for Console Redirec-

tion. The options are COM 1 and COM 2.

Serial Port Mode

This feature allows the user to set the serial port mode for Console Redirection.

The options are 115200 8, n 1; 57600 8, n, 1; 38400 8, n, 1; 19200 8, n, 1; and

9600 8, n, 1.

Flow Control

This feature allows the user to set the ﬂ ow control for Console Redirection. The

options are None, Hardware, and Software.

Redirection After BIOS POST

Select Disabled to turn off Console Redirection after Power-On Self-Test (POST).

Select Always to keep Console Redirection active all the time after POST. (Note:

This setting may not be supported by some operating systems.) Select Boot Loader

to keep Console Redirection active during POST and when the Boot Loader is

booting. The options are Disabled, Boot Loader, and Always.

Terminal Type

This feature allows the user to select the target terminal type for Console Redirec-

tion. The options are ANSI, VT100, and VT-UTF8.

VT-UTF8 Combo Key Support

Select Enabled to enable a terminal keyboard to send commands from a remote

console. The options are Enabled and Disabled.

Sredir Memory Display Delay

This feature deﬁ nes the length of time in seconds to display memory information.

The options are No Delay, Delay 1 Sec, Delay 2 Sec, and Delay 4 Sec.