User`s manual

4-22
X8DAH+/X8DAH+-F User’s Manual
Event Sensor Type•
Event Sensor Number•
Event Dir Type•
Event Data.•
Clear BMC System Event Log
Select OK and press the <Enter> key to clear the BMC system log. Select Cancel
to keep the BMC System log. The options are OK and Cancel.
Caution: Any cleared information cannot be recovered. Make absolutely
sure that you no longer need any data stored in the log before clearing
the BMC Event Log.
Set LAN Confi guration
Set this feature to confi gure the IPMI LAN adapter with a network address as shown
in the following graphics.
Channel Number - Enter the channel number for the SET LAN Confi guration
command. This is initially set to [01]. Press "+" or "-" to change the Channel
Number.
Channel Number Status - This feature displays the channel status for the
Channel Number selected above: "Channel Number is OK" or "Wrong Channel
Number".
IP Address Source
Select the source of the IP address for this system. If Static is selected, you will need
to know and manually enter the IP address of this machine. If DHCP is selected,
BIOS will search for a DHCP (Dynamic Host Confi guration Protocol) server in the
network it is attached to, and request the next available IP address. The options
are DHCP and Static.
The following items are assigned IP addresses automatically if DHCP is selected
under IP Address Source above:
IP Address
Enter the IP address for this machine. This should be in decimal and in dotted quad
form (i.e., 192.168.10.253). The value of each three-digit number separated by dots
should not exceed 255 as shown in the screen below.