User`s manual

Chapter 4: BIOS
4-5
SATA AHCI Legacy Enable
This setting allows you to disable SATA ports 5 and 6 while in this mode. The
options are Disabled and Enabled.
IDE Channel 0 Master/Slave/SATA Port2/SATA Port3
These settings allow you to set the parameters of slots indicated above. Hit <Enter>
to activate the following sub-menu screen for detailed options of these items. Set
the correct congurations accordingly. The items included in the sub-menu are the
following:
Type
This option allows you to select the type of storage or ROM drive. Auto allows
the BIOS to automatically determine the drive's type/capacity (number of heads,
etc.). User allows you to enter the parameters for the storage device installed on
this particular port. For hard drives, enter a number between 1 to 39 to select a
predetermined HDD type. Select CDROM if a CDROM drive is installed. Select
ATAPI if a removable disk drive is installed.
Note: Select User for any device or legacy device that is not supported or auto-
matically detected under Auto. This enables you to manually enter parameters
for devices that are not otherwise available in the BIOS' drive table.