User`s manual

Chapter 1: Introduction
1-5
Jumper Description Default Setting
JBT1 CMOS Clear (See Pg. 2-23)
JI
2
C1/JI
2
C2 SMB to PCI Slot#1/Slot#2 Speed Pins 2-3 (Disabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1/ JPL2 GLAN1/GLAN2 Enable Pins 1-2 (Enabled)
JWD Watch Dog Pins 1-2 (Reset)
Connector Description
ATX PWR (JPW1) Primary 24-Pin ATX PWR Connector
CPU PWR (JPW3) +12V 8-pin PWR
Chassis Intru.(J23) Chassis Intrusion Header
COM1/COM2 (JCOM1/2) COM1/COM2 Serial Port Connectors
DIMM#1A-DIMM#2B Memory DDR2 Fully Buffered DIMM Slots
FAN 1-5 Fans 3-5: System cooling/chassis fans, Fans 1-2:CPU
fans
Floppy (J22) Floppy Disk Drive Connector
FP Control (JF1) Front Control Panel Connector
GLAN 1/2 (JLAN1/2) G-bit Ethernet Ports
IDE#1 (JIDE1) IDE#1 Hard Drive
Keyboard/Mouse (JKM1) Keyboard/Mouse Connectors
PWR LED/SPKR (JD1) Power LED(pins1-3)/SpeakerHeader (pins 4-7)
PWR Force-On (JPF, JP2)Power Force-On
SATA0-SATA3 (JS1-JS4) Intel SATA 0-3 Connectors
Slot#4 (J6) PCI 33MHz Slot
Slot#6 (J10) PCI-Exp. x8 Slots
T-SGPIO (J26) Serial General Purpose Input/Output Header
USB 0/1 (J20) Back Panel USB 0/1
USB 2/3 (JUSB1) Front Panel Accessible USB 2/3
VGA (J15) VGA Port
WOL (JWOL1) Wake-on-LAN Header
WOR (JWOR1) Wake-on-Ring Header
LED Indicator Description
D31 Status LED (See Pg. 2-26)
LE1 Power LED (See Note 4 on the previous page.)
LE2/LE6 (See Pg. 2-27) CPU1 VRM Overheat(LE2)/CPU2 VRM Overheat (LE6)
LE4/LE5 POST-Code LED Indicators (See Pg. 2-26)
Note: Refer to Chapter 2 for more information on connectors and jumpers.
Quick Reference (X7DVL-L)