Datasheet

Chapter 1: Introduction
1-5
Jumper Description Default Setting
JBT1 CMOS Clear See Chapter 2
JI
2
C1/JI
2
C2 SMB to PCI/PCI-Exp Slots Open (Disabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPA1 (Note) SAS Enable Pins 1-2 (Enabled)
JPA2 (Note) Software RAID/IT RAID Mode Closed (Software RAID)
JPL1/ JPL2 GLAN1/GLAN2 Enable Pins 1-2 (Enabled)
JWD Watch Dog Pins 1-2 (Reset)
Connector Description
BPI
2
C Back Panel Power System Management (I
2
C) Header
COM1/COM2 COM1/COM2 Serial Port and Header
FAN 1-6 Fans 1-2: CPU Fans, Fans 3-6: System cooling fans
Floppy Floppy Disk Drive Connector (JFDD1)
FP Control Front Control Panel Connector (JF1)
IDE IDE Hard Drive
J7/J8/9/10 Serial-Links General Purpose Input/Output Headers
(J7/J8: SATA T-SGPIO 0/1, J9/J10: SAS T-SGPIO 0/1)
JAR1 Alarm Reset Header
JD1 Power LED(pins1-3)/SpeakerHeader (pins 4-7)
JIBTN1 I-Button Socket
JL1 Chassis Intrusion Header
JPW1 +12V 8-pin PWR
JPW2 Primary 24-Pin ATX PWR Connector
JPWF1 Power Supply Failure (See Chapter 2)
JUSB1/JUSB2/3 BP USB0/1 (JUSB1), FP USB2/3/4/5 (JUSB2/3)
JWOL Wake-on-LAN Header
JWOR Wake-on-Ring Header
Keylock Keylock Header (JKEY1)
LAN1/2 G-bit Ethernet Ports 1/2
PWR I
2
C Power System Management (I
2
C) Header (JPI
2
C1)
SAS0-SAS7 (Note) Serial Attached SCSI Connectors (#0-#7) (X7DCL-3)
SATA0-SATA5 SATA 0-5 Connectors
SIMLC IPMI SIMLC Slot (JIPMI)
VGA VGA Port
LED Indicator Description
LED1 SAS LED
LED3/LED4 Power LED (LED3)/System Status LED (LED4)
LED5/LED6 CPU1/CPU2 VRM Overheat (respectively)
Note: SAS is available on the X7DCL-3 only.
Quick Reference (X7DCL-3/X7DCL-i)