User`s manual

Chapter 2: Installation
2-15
ATX PS/2 Keyboard and PS/2
Mouse Ports
The ATX PS/2 keyboard and PS/2
mouse are located next to the Back
Panel USB Ports on the motherboard.
See the table at right for pin defi nitions.
PS/2 Keyboard/Mouse Pin
Defi nitions
PS2 Keyboard PS2 Mouse
Pin# Defi nition Pin# Defi nition
1 KB Data 1 Mouse Data
2 No Connection 2 No Connection
3 Ground 3 Ground
4 Mouse/KB
VCC (+5V)
4 Mouse/KB
VCC (+5V)
5 KB Clock 5 Mouse Clock
6 No Connection 6 No Connection
VCC: with 1.5A PTC (current limit)
SGPIO
The T-SGPIO1/T-SGPIO2 (Serial
General Purpose Input/Output)
headers provide a bus between the
SATA controller and the backpane to
provide SATA enclosure management
functions. Connect the appropriate
cable from the backplane to the
T-SGPIO1 header to utilize SATA
management functions on your system.
Likewise, the 6-SGPIO1/6-SGPIO2
headers provide the same function
between the SAS controller and the
backpane, and have the same pin
definitions (only on H8SML-7 and
H8SML-7F).
SGPIO Header Pin Defi nitions
(T-SGPIO1/TSGPIO2)
(6-SGPIO1/6-SGPIO2))
Pin# Defi nition Pin# Defi nition
1 NC 2 Data
3 Ground 4 Data
5 Load 6 Ground
7 CLK 8 NC
Note: NC indicates no connection.
SMBus Header
The JIPMB1 header at SMBus is
for the System Management Bus.
Connect the appropriate cable here
to utilize SMB on the system. See the
table on the right for pin defi nitions.
SMBus Header
(SMBus)
Pin Defi nitions
(JIPMB1)
Pin# Defi nition
1 Data
2 Ground
3 Clock
4 No Connection