User`s manual

H8SML-7/i(F) SERVERBOARD USER'S MANUAL
2-8
Support
The H8SML-7/i(F) serverboard supports single/dual channel,
DDR3-1600/1333/1066 Mhz speed Unbuffered ECC/non-ECC SDRAM.
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
Maximum memory for the H8SML-7/i(F) serverboard is up to 32 GB of DDR3
Unbuffered ECC SDRAM in four (4) slots.
Figure 2-1. DIMM Installation
To Install: Insert module
vertically and press down
until it snaps into place.
Pay attention to the
alignment notch at the
bottom.
To Remove: Use your
thumbs to gently push
the release tabs near both
ends of the module. This
should release it from
the slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should
align with the receptive
key point on the slot.
Notch Notch
Front View