User`s manual

Chapter 4: BIOS

4-5

 Floppy/IDE/SATA Conﬁ guration

Floppy A

Move the cursor to these ﬁ elds via up and down <arrow> keys to select the

ﬂ oppy type. The options are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB

3½", 1.44 MB 3½”, and 2.88 MB 3½".

Floppy B

Move the cursor to these ﬁ elds via up and down <arrow> keys to select the

ﬂ oppy type. The options are Disabled, 360 KB 5 1/4", 1.2 MB 5 1/4", 720 KB

3½", 1.44 MB 3½”, and 2.88 MB 3½".

Onboard Floppy Controller

Use this setting to Enable or Disable the onboard ﬂ oppy controller.

HT1000 S-ATA

Use this setting to Enable or Disable the SATA controller in the HT1000

chipset.

S-ATA Mode

Use this setting to specify the SATA mode: either IDE or MMIO.

Onboard PCI IDE Controller

The following options are available to set the IDE controller status: Disabled will

disable the controller. Primary will enable the primary IDE controller. There is

no Secondary option since only one IDE slot is provided on the board.

Primary IDE Master/Slave

Highlight one of the two items above and press <Enter> to access the submenu

for that item.

Type

Select the type of device connected to the system. The options are Not In-

stalled, Auto, CDROM and ARMD.