User's Manual (1.2a)

Chapter 2: Installation
2-17
Wake-On-LAN
The Wake-On-LAN header is
designated JWOL1. See the table on
the right for pin defi nitions. You must
have a LAN card with a Wake-On-LAN
connector and cable to use the Wake-
On-LAN feature.
Wake-On-LAN
Pin Defi nitions
(JWOL1)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
Universal Serial Bus Ports
Two Universal Serial Bus ports (USB
2.0) are located beside the Keyboard
and Mouse PS2 ports (USB0/1). Two
additional Type A ports (USB6/7) are
also included on the motherboard. See
the table on the right for pin defi nitions.
Universal Serial Bus Ports
Pin Defi nitions (USB 0/1,
USB6/7)
USB0
Pin# Defi nition
USB1
Pin# Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
DOM Power Connector
A power connector for SATA DOM
(Disk_On_Module) is located at JWF1.
Connect the appropriate cable here to
provide power support for your DOM
devices.
DOM PWR
Pin Defi nitions
Pin# Defi nition
1 +5V
2 Ground
3 Ground
LAN1/2 (Ethernet Ports)
Two Gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside
the VGA port. Additionally, for the
H8DG6/i-F serverboards, there is a
dedicated LAN for IPMI on top of the
two rear USB ports. These Ethernet
ports accept RJ45 type cables.
LAN Ports (LAN1/2)
Pin Defi nition
Pin# Defi nition Pin# Defi nition
1 P2V5SB 10 SGND
2 TD0+ 11 Act LED
3 TD0- 12 P3V3SB
4 TD1+ 13 Link 100 LED
(Yellow, +3V3SB)
5 TD1- 14 Link 1000 LED
(Yellow, +3V3SB)
6 TD2+ 15 Ground
7 TD2- 16 Ground
8 TD3+ 17 Ground
9 TD3- 18 Ground
Note: NC indicates no connection.