User's Manual (1.2a)

H8DG6/i(-F) SERVERBOARD USER'S MANUAL

2-8

2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/

DIMM4A, etc. Always install in groups of four and in the numerical order of

the DIMM slots. See support information below.

3. Gently press down on the memory module until it snaps into place.

4. With four DIMMs installed, repeat step 2 to populate the CPU2 DIMM

slots. Always install four DIMMs to both CPU DIMM slots for more efﬁ cient

operation.

Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are

supported. It is highly recommended that you remove the power cord from the

system before installing or changing memory modules. Please refer to our web site

for memory that has been tested on the H8DG6/i(-F) serverboard.

Memory Support

The H8DG6/i(-F) serverboard supports single/dual/tri/quad channel,

DDR3-1600/1333/1066 Mhz speed registered ECC/Unbuffered ECC/non-ECC

SDRAM.

Populating four adjacent slots at a time with memory modules of the same size and

type will result in interleaved (128-bit) memory, which is faster than non-interleaved

(64-bit) memory.

Maximum Memory

The H8DG6/i(-F) serverboard supports a maximum of up to 128 GB of ECC/Non-

ECC UDIMM or 512 GB of ECC RDIMM in sixteen (16) DIMM slots.

Figure 2-1. Installing DIMM into Slot

To Install: Insert

module vertically and

press down until it

snaps into place.

Pay attention to the

alignment notch at

the bottom.

To Remove: Use

your thumbs to gently

push the release tabs

near both ends of the

module. This should

release it from the

slot.

Top View of DDR3 Slot

Release Tab Release Tab

Note: Notch should align with

the receptive key point on

the slot.

Notch

Front View