User`s manual

SC846 Chassis Manual
4-20
2. Install the xed hard drive into the hard drive tray using four round head
screws (6-32) and two Mylar washers.
Figure 4-22: Securing the Fixed Hard Drive into the Tray
Figure 4-23: Installing the HDD and HDD Tray in the Chassis
3. Lower the drive and tray into the chassis, carefully inserting the lower rubber-
lined holes onto the pins at the base of the chassis and aligning the upper
rubber holes with the holes in the chassis.
4. Use the two drive tray screws with Mylar washers to secure the hard drive
and drive tray on the standoff power supply cage.
Screw
6-32
Mylar
Washer
Screw
6-32
Fixed
Screw
6-32
Install the hard drive and
hard drive tray into the
chassis using two screws
and two Mylar washers.