User`s manual

SC846 Chassis Manual
4-18
3. Remove the two screws securing the power distributor housing to the chassis
wall
4. Remove the three screws securing the power distributor to the housing.
5. Gently pull the power distributor and housing from the chassis. Carefully
guide all the cables through the power distributor housing.
6. Remove the power distributor from the housing.
7. Slide the new power distributor module into the power distributor housing.
Make sure that you slide the cables through the bottom of the housing.
8. Reconnect all the cables, replace the power supply, plug the power cords
back into the power supplies and power up the system.
Figure 4-20: Removing the Power Distributor and Housing