User`s manual

5-17

Chapter 5 Chassis Setup and Maintenance

Installing the DVD-ROM and Peripheral Drive

SC842 chassis models supports a slim DVD-ROM and up to three 5-1/4" periph-

eral drives.

Figure 5-14: Installing a Peripheral Drive

Installing a Peripheral Drive

1. Shut down the system using the operating system, remove the power cord

from the rear of the chassis and open the chassis cover.

2. If adding a drive to the chassis, remove the mini-bezel from the drive bay

The mini-bezel is the small grating that covers the drive bay. Remove this by

simply pulling it out of the bay.

3. If replacing an existing drive, remove the existing drive by depressing the

release tab, then pulling the drive out of the chassis.

4. Attach the two guide screws which are included in the accessory box.

5. Insert the new drive unit in the slot until the release tab locks into place.

6. Connect the data and power cables to the motherboard.

Release Tab

Guide Screws