User`s manual

5-17
Chapter 5 Chassis Setup and Maintenance
Replacing or Installing the DVD Drive
DVD Drive Installation
Power down and unplug the system.1.
Remove the chassis cover.2.
(If you are not installing a new front port panel) 3. Remove the mini-bezel
(grate) from the drive bay The mini-bezel is the small grating that covers the
drive bay. Remove this by simply pulling it out of the bay.
(If you are installing a new front port panel) Remove the old drive by de-
pressing the release tab, then pulling the drive out of the chassis.
Insert the new drive unit in the slot until the tab locks into place.4.
Connect the data and power cables to the backplane and if necessary, the-5.
motherboard.
For more information, see the manual for your backplane in the appendix
Replacing or Installing the Floppy Drive
Installing a Floppy Drive
Power down and unplug the system.1.
Remove the chassis cover.2.
(If you are not installing a new front port panel) 3. Remove the mini-bezel
(grate) from the drive bay The mini-bezel is the small grating that covers the
drive bay. Remove this by simply pulling it out of the bay.
(If you are installing a new front port panel) Remove the old drive by de-
pressing the release tab, then pulling the drive out of the chassis.
Insert the new drive unit in the slot until the tab locks into place.4.
Connect the data and power cables to the backplane and, if necessary, 5.
motherboard.
For more information, see the manual for your backplane in the appendix.