User`s manual

5-13
Chapter 5: Chassis Setup and Maintenance
Mobile Rack
Hard Drive
Rails
Pull the rst drive release tab and push the drive carrier toward the front of 3.
the chassis. Repeat this for all three tabs.
Hard Drive Rails
Hard Drive Carrier
Figure 5-13: Removing the Hard Drive Rails
Figure 5-14: Adding Hard Drive Rails to a Storage Rack
Remove the hard drive carrier rails from the hard drive tray. To do this, you 4.
must remove two screws from each side. Do this for all three hard drive car-
riers.
Attach the rails to a DVD-ROM, CD-ROM, oppy drive, or other peripheral. 5.
The rails should t any standard sized peripherals.
Install two hard drive rails to the mobile rack. Each individual rail requires two 6.
screws. Also, make sure the arrow on the rail points toward the front of the
chassis.
Slide the mobile rack into the storage module and chassis.7.